Signs your well pump or pressure tank needs attention
Check the breaker for the pump circuit before anything else, because that one is free. If the pump kicks on when nobody is using water, the pump is fine and you have a leak, which is leak detection. If the water is sandy or smells, that is water treatment and filtration rather than the pump. If the water itself is the complaint rather than the pressure, start with whole home water filtration.
- No water, or very low pressure
- Faucets sputtering air
- The pump cycling on and off rapidly
- The pump running without shutting off
- A sudden spike in the electric bill
- Dirty or sandy water from the tap
How we tell a pump problem from a tank problem
This is the question that decides whether you are spending a few hundred dollars or a few thousand, so we test it rather than guess. A diagnosis and well test is $150 to $350, and you get the answer before anybody quotes you for the expensive option.
No water at all is usually the pump side
With the breaker on and the gauge reading nothing, you are looking at the pump, the pressure switch or the control box. A switch is $250 to $450 and a control box $300 to $600, and both are a same-visit fix. See well pump repair.
Short cycling is always the tank side
A pump starting and stopping every few seconds is a tank that has lost its air charge or its bladder, not a failing pump. It is cheap this week. Left alone it is a dead pump within months. See pressure tank repair.
Replace the pump when it has earned it
Eight to fifteen years is normal, and sandy water, constant cycling and lightning all shorten it. Pulled and replaced runs $1,600 to $3,800 depending on how deep it sits. See well pump installation and replacement.
Replace the tank when the bladder has gone
A ruptured bladder cannot be recharged, whatever anyone tells you. A tank is $600 to $1,500, and quite often the tank is what actually failed rather than the pump. See pressure tank installation and replacement.
Pump or tank, pick the one you need
- Well pump repair: No water, sputtering, breaker tripping
- Well pump installation: Submersible and jet pump replacement
- Pressure tank repair: Short cycling, switches, and air charge
- Pressure tank installation: Sized right so the pump lasts
Why the Shore calls us when the well stops
From large commercial projects to a dripping faucet, the work gets the same treatment: diagnosed correctly, repaired carefully, guaranteed in writing.
Stocked for the Shore
There is no supply house around the corner out here, so we carry more inventory in the shop and on the trucks than most companies our size carry anywhere.
Who actually shows up
A Shoresteady Plumbing technician who has been background checked and drug tested. We provide clear estimates before work begins.
No surprise on the invoice
You approve a written estimate before work begins. If the job needs something we did not see, we stop and talk to you first. Financing through Acorn Finance is available.
Guaranteed in writing
2-year workmanship
Our guarantee on the labor, on every job we do.
Manufacturer warranty
Passed through to you in full on everything we install.
100% satisfaction
If it is not right, we come back and make it right.
Questions We Get Asked About Well Pumps
What people ask when the taps have gone quiet.
Is it the well pump or the pressure tank?
No water at all points at the pump, the pressure switch or the control box. A pump switching on and off every few seconds points at the tank. We test rather than guess, because the two are hundreds of dollars apart. The comparison is above.
Will you try to sell me a new pump?
We diagnose before we quote. A good share of no-water calls turn out to be a pressure switch at $250 to $450 or a control box at $300 to $600, and when that is what it is, that is what we fit. When the pump really has failed we show you why before we price it.
What are your hours?
Monday through Sunday, 8:00am to 9:00pm, and no water goes to the front of the schedule. The price is the same on a Sunday evening as it is on a Tuesday morning. Anything after 9:00pm gets a call back first thing.
How much does well pump work cost?
Diagnosis and a well test is $150 to $350. A pressure switch is $250 to $450, a pressure tank $600 to $1,500, and a submersible pump pulled and replaced $1,600 to $3,800 depending on depth. Full ranges are in our well pump cost guide.
Do you keep well pumps in stock?
Common submersible pumps, tanks, switches, and controls ride on our trucks and sit in our own shop in Temperanceville. Out here that is the difference between water tonight and water on Thursday.
Explore related services
- Everything we install, repair, replace, and maintain
- Well pump repair on the Eastern Shore
- Well pump installation and replacement on the Shore
- Pressure tank repair on the Eastern Shore
- Pressure tank installation and replacement on the Shore
- Water leak detection on the Eastern Shore
- Water treatment and filtration installation, repair and replacement
- Whole home water filtration installation and replacement
- What the Shore says about us
- One membership. Every plumbing system in your house, looked after
- Plumbers who actually live on the Eastern Shore
- How Much Does Well Pump Replacement Cost on Virginia’s Eastern Shore
- Plumbing services on the Eastern Shore
- Water heater installation, repair, and replacement
- Tankless water heater installation, repair, and replacement
- Plumbing fixture installation, repair, and replacement
- Repiping and whole-home pipe replacement
- Water leak repair on the Eastern Shore
- Drain cleaning and clogged drains
- Sewer line installation, repair, and replacement
- Sump pump installation, repair, and replacement
- Commercial plumbing on the Eastern Shore
Ready for a steady hand?
Book with our team, or call us seven days a week from 8am to 9pm.
Call (757) 824-9862